Dahua DHI-ARC3008C - 4 G Module (Optional); Dimensions; Installing 4 G Modules

Alarm Control Panel Installer Manual
32
Submenu
Setting
RAPID
Select which areas to adopt rapid arming without entering the access code.
Rapid arming can be allocated to one or more Areas from this keypad.
Press the number of the Area to enable or disable the Area. Press to
continue.
After at least one Area is selected, the next programming steps ARMING
(DELAYED or IMMEDIATE) and FORCED ARM (YES or NO) will be shown.
Press and hold for three seconds to prompt rapid arming.
ARMING
FORCED ARM
BUZ. ON/OFF
Enable or disable the keypad buzzer.
BUZ. ENTRY
Enable or disable the keypad buzzer for the entry delay.
BUZ. EXIT
Enable or disable the keypad buzzer for the exit delay.
BUZ. ALARM
Enable or disable the keypad buzzer for the sound of alarm.
BUZ. CHIME
Enable or disable the keypad buzzer for the sound of the CHIME alarm
event.
KEYPAD BEEP
Enable or disable the beep when the keypad keys are pressed.
BACKLIGHT
Enable or disable automatic backlight illumination in the event of an alarm
or in the Entry Delay and Exit Delay status.
BUS ERRORS
Show the communication errors that have occurred between the keypad
and the Control Panel.
Press to return to the keypads selection menu. Step 4
Then you can continue with programming other keypads, or press to return to the KEYPADS
menu from where you can press and to move to the next menu or press to exit
from the Installer Menu.
COMMUNICATOR 1.22
After entering the Installer Menu, press and to scroll up and down until you reach the Step 1
COMMUNICATOR menu. See Figure 1-18.
Communicator Figure 1-18
Press to enter the programming mode. Step 2
Configure the settings. See Table 1-12. Step 3