Dahua DHI-ARC3008C - Wired Zones

Alarm Control Panel Installer Manual
41
OUTPUTS 1.26
1.26.1 Entering OUTPUT Menu
After entering the Installer Menu, press and to scroll up and down until you reach the Step 1
OUTPUTS menu. See Figure 1-22.
Outputs Figure 1-22
Press to enter the programming mode. Step 2
Press and to select an output that you want to configure, and then press . Step 3
By pressing + 2, you can enter the EDITING mode for changing the description of Output.
Configure the settings. See Table 1-15. Step 4
Press and to alter the options. Press to confirm the setting and move to the next
submenu.
The two numeric fields 000.00 represent minutes and seconds.
Table 1-15 Outputs settings
Submenu
Setting
STATE
Set the mode according to the installation requirements.
ACTIVE: The wire output is fully operational.

ISOLATE: The wire output is programmed but permanently bypassed

from the system.
OFF: The wire output is not used.

CATEGORIES
Set the output categories. For details, see "1.26.2 Configuring OUTPUT
Categories."
AREAS

ZONES

LINK

GENERIC

SYSTEM

Press to return to the OUTPUTS Menu. Step 5
Then you can continue with programming other outputs, or press to return to the OUTPUTS
menu from where you can press and to move to the next menu or press to exit
from the Installer Menu.