Dahua DHI-ARC3008C - Power Supplies

Alarm Control Panel Installer Manual
40
Submenu
Setting
ZONE1/ZONE2
Select the zones that you want to combine the alarm linkage.
To select the zone number, type in the number and press to confirm
the input. You can also press and to adjust the number.
 The IN AND ZONES can consist of any combination of wired or
wireless zones and a single Zone can also be placed in AND by itself.
However, it is suggested not to program Zones in AND which are of the
delayed, robbery, or panic type as the AND result might not guarantee
a sufficient level of security.
 Setting a Zone in AND by itself means that a double alarm confirmation
will be obtained for the alarm to activate. This option is very useful for
placing a filter on the first alarm from a Zone at a high risk of a FALSE
ALARM.
IN SEQUENCE
Establish whether the alarm confirmation between the two zones should
take into account the first and second sequence.
YES: When the alarm is triggered in ZONE1, the alarm in ZONE2 must

be triggered afterwards.
NO: The control panel will not take the sequence into account.

TRIGGERS
Establishes the maximum number of alarms that the same Zone triggering
the alarm. In practice, a filter is enabled, from a minimum value of 02 (two
alarms) that takes into account the alarms permitted to the Zone before
triggering the alarm. The maximum value that can be set is 15.
Using the TRIGGERS parameter with the criterion could have a negative
effectiveness and promptness of the installed alarm system.
AND TIME
Set the time within which the alarm from the ZONE2 must be triggered after
the alarm of ZONE1 starts.
If the ZONE2 opens in this time window, the alarm is confirmed; otherwise,
after this time period, the timer is reset to zero and the first alarm is reset.
The time can be programmed in minutes and seconds.
Press to finish programming of the ZONE1 pair in AND.
Press to return to the IN AND ZONES menu. Step 5
Then you can continue with programming other IN AND ZONES, or press to return to the IN
AND ZONES menu from where you can press and to move to the next menu or press
to exit from the Installer Menu.