Alarm Control Panel Installer Manual
52
Set the disarming time period for the patrol user. If you set the time to 0,
disarming is not allowed.
Set the time period for the test mode of zone. After this period, the zone
returns to ACTIVE.
Technician Timer Program.
Set the maximum time available for TEHCNICIAN to program the system
after user authorization. Valid time from 01 to 10 hours.
Press to return to the SYSTEM TIMING menu. Step 4
Then you can press and to move to the next menu or press to exit from the
Installer Menu.
SYSTEM TIMERS 1.30
After entering the Installer Menu, press and to scroll up and down until you reach the Step 1
SYSTEM TIMERS menu. See Figure 1-27.
System timer Figure 1-27
Press to enter the programming mode. Step 2
Press and to select the Timer that you want to configure, and then press . Step 3
By pressing + 2, you can enter the EDITING mode for changing the description of timer.
Configure the settings. See Table 1-24. Step 4
Press and to alter the options. Press to confirm the setting and move to the next
submenu.
Table 1-24 System timer settings
ISOLATE: Timer enabled but temporarily locked.
START/STOP: The timer applies to arming and disarming, access code
duration and LINK OUTPUT duration.
STAR: The timer applies to arming only.
STOP: The timer applies to disarming only.
To Next Page
Loading...
