Dahua DHI-ARC3008C - Page 55

Alarm Control Panel Installer Manual
54
User type
Authority level
Master
Operations only on the Areas that are assigned to Master. The Master can
only change his own code and those of a lower level and access the User
Menu up to option 9.
User
Operations only on the Areas that are assigned to User. The User can only
change his own code and access the User Menu up to option 8.
Temporary
Valid only for an arming and disarming operation. The Temporary does not
have access to the User Menu.
Duress
Valid only for arming and disarming with automatic activation of the duress
output. The Duress does not have access to the User Menu.
Patrol
Valid only for disarming operation. When the patrol time ends, the Zones are
automatically armed again.
1.31.2 Configuring Authority Level
After entering the Installer Menu, press and to scroll up and down until you reach the Step 1
ACCESS CODES menu. See Figure 1-28.
Access codes Figure 1-28
Access Code 1 is always the Supervisor code. From 2 onwards it is possible to program users with
an authority level. You can set up to 99 access codes.
Press to enter the programming mode. Step 2
Press and to select an access code that you want to configure, and then press . Step 3
Set the authority parameters. See Table 1-26. Step 4
 For Supervisor and Manager, you only need to set STATUS, LEVEL, ARMING, FORCED ARM,
and LINK submenus. For Master, User, Temporary, and Duress, you should set all the
submenus.
 On each submenu, press and to alter the options. After setting each submenu,
press to enter the next submenu.
Table 1-26 Access code level and submenus
Submenu
Setting
STATUS
Set the code to an operating or non-operating status.
ACTIVE

ISOLATE

LEVEL
Give an authority level to the user. For the different authority level, see
"1.31.1 Authority Level."