Dahua DHI-ARC3008C - SMS Messages

Alarm Control Panel Installer Manual
73
Category
Event No.
Setting
CID Code
356
Wired Zone 3 Tamper
144
357
Wired Zone 4 Tamper
144
358
Wired Zone 5 Tamper
144
359
Wired Zone 6 Tamper
144
360
Wired Zone 7 Tamper
144
361
Wired Zone 8 Tamper
144
362
Wired Zone 1 Exclusion
570
363
Wired Zone 2 Exclusion
570
364
Wired Zone 3 Exclusion
570
365
Wired Zone 4 Exclusion
570
366
Wired Zone 5 Exclusion
570
367
Wired Zone 6 Exclusion
570
368
Wired Zone 7 Exclusion
570
369
Wired Zone 8 Exclusion
570
Press to return to the DIGITAL FORMAT menu. Step 4
Then you can press and to move to the next menu or press to exit from the
Installer Menu.
TCP/IP NETWORK 1.40
After entering the Installer Menu, press and to scroll up and down until you reach the Step 1
TCP/IP NETWORK menu. See Figure 1-42.
TCP/IP network Figure 1-42
Press to enter the programming mode.
Step 2
Configure the settings. See Table 1-36. Step 3
Table 1-36 TCP/IP network setting
Submenu
Setting
DHCP
YES: Select YES if the automatic assignment mode for the IP address

is active on the network.
NO: Select NO is the address setting is done manually in the next

programing steps.