Dahua DHI-ARC3008C - Page 76

Alarm Control Panel Installer Manual
75
Press to return to the log event selection menu. Step 5
Then you can continue with viewing other log events, or press to return to the LOG EVENT
menu from where you can press and to move to the next menu or press to exit
from the Installer Menu.
2G/4G MODULE 1.42
After entering the Installer Menu, press and to scroll up and down until you reach the Step 1
2G/4G MODULE menu. See Figure 1-45.
2G/4G module Figure 1-45
Press to enter the programming mode. Step 2
Configure the settings. See Table 1-37. Step 3
Table 1-37 2G/4G module setting
Submenu
Setting
2G/4G ENABLE
YES

NO

P2P ENABLE
ENABLE: Enables the DMSS app to access the Control Panel.

DISABLE: Disables the DMSS app to access the Control Panel.

Press to return to the 2G/4G MODULE menu. Step 4
Then you can press and to move to the next menu or press to exit from the
Installer Menu.
LANGUAGE 1.43
After entering the Installer Menu, press and to scroll up and down until you reach the
Step 1
LANGUAGE menu. See Figure 1-46.
Language Figure 1-46
Press to enter the programming mode. Step 2
Press and to select a system language. Step 3