SNMP: Choose SNMP v3, and set up strong encryption passwords and authentication passwords.
SMTP: Choose TLS to access mailbox server.
FTP: Choose SFTP, and set up strong passwords.
AP hotspot: Choose WPA2-PSK encryption mode, and set up strong passwords.
7. MAC Address Binding
8. Assign Accounts and Privileges Reasonably
9. Disable Unnecessary Services and Choose Secure Modes
10. Audio and Video Encrypted Transmission
11. Secure Auditing
12. Network Log
In order to better ensure the safety of device and reduce potential cyber risks, we recommend:
13. Construct a Safe Network Environment
More information
We suggest you to enable HTTPS, so that you visit Web service through a secure communication
channel.
6. Enable HTTPS
26
User’s Manual
We recommend you to bind the IP and MAC address of the gateway to the device, thus reducing
the risk of ARP spoofing.
According to business and management requirements, reasonably add users and assign a
minimum set of permissions to the.
If your audio and video data contents are very important or sensitive, we recommend that you
use encrypted transmission function, to reduce the risk of audio and video data being stolen
during transmission.
Reminder: encrypted transmission will cause some loss in transmission efficiency.
Due to the limited storage capacity of the device, the stored log is limited. If you need to save the
log for a long time, it is recommended that you enable the network log function to ensure that
the critical logs are synchronized to the network log server for tracing.
Please visit Dahua official website security emergency response center for security
announcements and the latest security recommendations.
Check online users: we suggest that you check online users regularly to see if the device is
logged in without authorization.
Check device log: By viewing the logs, you can know the IP addresses that were used to log in
to your devices and their key operations.
Disable the port mapping function of the router to avoid direct access to the intranet devices
from external network.
The network should be partitioned and isolated according to the actual network needs. If there
are no communication requirements between two sub networks, it is suggested to use VLAN,
network GAP and other technologies to partition the network, so as to achieve the network
isolation effect.
Establish the 802.1x access authentication system to reduce the risk of unauthorized access to
private networks.
Enable IP/MAC address filtering function to limit the range of hosts allowed to access the
device.
If not needed, it is recommended to turn off some services such as SNMP, SMTP, UPnP, etc., to
reduce risks.
If necessary, it is highly recommended that you use safe modes, including but not limited to the
following services:
To Next Page
Loading...
Need help?
General
