24
z Use the screwdriver to loosen the 3G card protection cap screw in the side panel, and then
remove the 3G card protection cap from the camera.
z Install the 3G card to the camera according to the proper installation position.
z Put the 3G card protection cap back.
z Use the screwdriver to fix the 3G card protection cap screw firmly to secure the 3G card
protection cap.
Figure 3-7
Figure 3-8
3.3.2 Remove
Please follow the steps listed below to remove 3G card. The interface is shown as Figure 3-9.
z Use the screwdriver to loosen the screw of 3G card protection cap in the rear panel.
Remove the cap from the camera.
z Follow the 3G card direction to remove the 3G card.
z Insert the 3G card protection cap.
z Use the screwdriver to fix the screw to secure the protection cap.
Figure 3-9
To Next Page
Loading...
Need help?
General
