Dahua Mobile DVR Series - 2 Device Installation; Device General Introduction; Front Panel

Mobile DVR Installation Instruction Guide
5
2 Device Installation
2.1 Device General Introduction
2.1.1 Front Panel
The front panel is shown as in Figure 2-1.
Figure 2-1
Please refer to the following sheet for front panel button information.
SN
Name
Port and Indicator Light
1
RJ45 Ethernet port
1 network port.
USB port
2 USB ports to connect to mouse or flash disk to backup
data.
2
Door lock/unlock
(Device on/off
button)
 Please unlock the device before you remove the
HDD box. Otherwise system is going to shut
down automatically.
 System cannot boot up once the button is unlock.
Please lock the device first and the boot up the
device. It is to protect the HDD.
3
PWR
Power indicator light.
 The red light is on when the device is running.
 The light is off when the device is off.
4
REC
Record indicator light.
 The blue light is on when system is recording.
 The light is off when system is not recording.
5
HDD
HDD indicator light.
 The blue light is on when there is HDD.
 The light is off when there is no HDD.
6
ALM
Alarm indicator light.
 The blue light is on when there is an alarm.
 The light is off when there is no alarm.
7
IR
It is to receive the signal from the remote control.