7
Device initialization Figure 4-1
Enter and confirm the password, and then click Next. Step 3
The email setting interface is displayed.
The password should consist of 8 to 32 non-blank characters and contain at least two
types of characters among upper case, lower case, number, and special character
(excluding ' " ; : &).
Select the Email check box, and then enter your email address. Step 4
This email address is used to reset the password.
Click Next. Step 5
The initialization succeeded.
Click OK. Step 6
Login interface Figure 4-2
Enter username and password, and then click Login to log in to the web interface. Step 7
The username is admin by default; the password is the one that you set in Figure 4-1.
To Next Page
Loading...