-S3-
1) Only qualified personnel should perform grounding work of the welding power supply and
workpiece, or a workpiece and powered peripheral jigs while abiding by domestic regulations.
2) Do not touch live electrical parts.
3) Always wear dry insulating gloves and other body protection. Do not wear torn or wet gloves/
work clothes.
4) Before doing the installation, inspection, maintenance, etc. of this product be sure to turn off
all the input power sources and check, several minutes later, that there is no charging voltage
since the condenser and the like may have been recharged.
5) Do not use cables with insufficient capacity, with damage, or with naked conductors.
6) Be sure to tighten the connections of cables and insulate them in order to prevent personnel
from touching those parts easily.
7) DO NOT use a welding machine with its case or cover removed.
8) Secure a firm foothold before initiating work. DO NOT perform work with an unstable
foothold or with a foothold at a height of two meters or above.
9) Make periodic inspection and maintenance. Damaged parts should be repaired before use.
10) Turn off POWER switch when not in use.
2.3 All the personnel in and around the working area including an operator should wear
appropriate protection to protect themselves from arc rays, spatters, slag, and noise
produced by welding.
●Install a lightproof wall where arc is generated.
WARNING
●Wear appropriate eye, ear, and body protection.
●Arc rays may cause inflammation of eyes and burns on skin
●Spatter s and slag may cause eye troubles and burns.
●Noise may cause hearing problems.
1) Wear lightproof glasses or a welder’s shield helmet with a proper shade of filter when welding
or watching a welder work.
2) INSTALL ARC PROTECTIVE CURTAINS in between an operator and arc rays.
3) WEAR PROPER SAFETY GLASSES in work area at all times.
4) WEAR PROPER EAR PROTECTION.
5) WEAR PROPER BODY PROTECTION including woolen clothing, flameproof apron and
gloves, leather leggings, high boots and leather arm and shoulder gauntlets.
6) WEAR PROPER SAFETY GLASSES to protect eyes and skin from spatters and slag.
IMPORTANT SAFEGUARD (continued)
To Next Page
Loading...
Need help?
General
