Daihen OTC Almega AX Series User Manual

No. 1L22440-E-10
A
X
series
INSTRUCTION MANUAL
WELDING INTERFACE
(DIGITAL)
■ Read and follow these instructions and all safety blocks carefully.
■ Have only trained and qualified persons install, operate, or service this unit.
■ Give this manual to the operator.
■ For help, call your distributor.

Daihen OTC Almega AX Series Specifications

General

Brand	Daihen
Model	OTC Almega AX Series
Category	Welding Accessories
Language	English

Summary

Read Instruction Manuals Before Use

Training Courses and Limited Warranty

Training Courses

Information on safety, operation, and maintenance training courses.

Limited Warranty

Details on DAIHEN Corporation's product warranty terms and conditions.

Safety Notes and Precautions

Notes on Safety

Guidelines for safe operation, including DANGER, WARNING, CAUTION, and IMPORTANT.

Chapter 1 Introduction

1.1 Welding Interface (Digital) Overview

General description of the Welding Interface (Digital) and its benefits.

1.2 Main Specifications

Key specifications including hardware, controllers, and power sources.

1.3 Standard Configuration

Describes the standard system configuration for robot welding.

1.4 Welding Mode Lists

Lists available welding modes for various Welbee Inverter series power sources.

Chapter 2 Connections

2.1 Connect Welding Interface (Digital)

Detailed procedures for connecting the Welding Interface (Digital) board.

2.2 Electrical Connection Diagram

Diagrams illustrating the electrical connections for various models.

Chapter 3 Configurations

3.1 Workflow

Overview of the setup process for Welding Interface (Digital).

3.2 Configuration Preparations

Prepares the setup tool and USB memory for configuration.

3.3 Configuring the Robot Controller

Procedures for registering power sources, modes, and creating backups.

3.4 Creating Setup Data

Steps to create setup data for robot controller and interface.

3.5 Writing Setup Data

Procedure to write created setup data to the robot controller and interface.

3.6 Check the Configuration

Verifies that the configuration and connections are performed correctly.

3.7 Configuring Welbee Inverter Series Welding Power Source

Describes front panel operations and internal functions of the power source.

3.8 Welding Conditions of WB-M350L/M400L

Details on welding condition parameters and points for setting them.

3.9 Welding Conditions of WB-M350/M400/M500

Details on welding condition parameters and points for setting them.

3.10 Welding Conditions of WB-P350/P400

Details on welding condition parameters and points for setting them.

3.11 Welding Conditions of WB-P350L/P400L/P500L

Details on welding condition parameters and points for setting them.

3.12 Welding Conditions of WB-W350/W400

Details on welding condition parameters and points for setting them.

3.13 Welding Conditions of WB-A350P/A500P

Details on welding condition parameters and specific welding types.

Chapter 4 Maintenance

4.1 Displaying Welding Interface (Digital) Version

Procedure to display the firmware version of the Welding Interface (Digital).

4.2 Welding Interface (Digital) Error Codes

List of error codes for the Welding Interface (Digital) and their measures.

4.3 Errors of Welbee Inverter Series Welding Power Source

Describes errors detected by the Welbee Inverter series welding power source.

4.4 Warranty and Liability Notes

Information on warranty scope, limitations, and disclaimers.