Daihen OTC Almega AX Series User Manual

1.1
1-1
Welding Interface (Digital)
1.1 Welding Interface (Digital)
When "Welding Interface (Digital)" is used, the latest Welbee Inverter series welding power source can be
connected to an AXC controller using digital communication. Compared to Welding Interface (AXWF-10**) that is
connected using analog signals, many more welding parameters that are available in the Welbee Inverter series
welding power source can be controlled by the robot controller. Also, various useful functions are available, such
as the real-time monitoring of the welding current and voltage during welding.
When the interface is used, D series welding power sources shown in Table 1.2.3 that are connected to the AXC
control
l
er can be easily replaced with Welbee Inverter series welding power sources. In this case, you only need
to adjust the welding conditions. You can continue using the existing programs and welding condition file.
Connect the Welbee Inverter series weldin
g
power source to the AXC controller
A
XC
Welbee Inverter series
W
elding
Interface
(Digital)
Di
g
ital communication
D series
Replace
F
i
gure 1.1.1 Overview of Welding Interface (Digital)

Daihen OTC Almega AX Series Specifications

General

Brand	Daihen
Model	OTC Almega AX Series
Category	Welding Accessories
Language	English