Daihen OTC Almega AX Series User Manual

3.12 Welding conditions of WB-W350/W400
3-48
3.12 Welding conditions of WB-W350/W400
This section describes the welding conditions that can be set when WB- W350 / W400 is connected.
3.12.1 About the welding condition parameters
The welding conditions that can be set when WB- W350 / W400 is connected using the interface
are shown in Table 3.12.1. Welding condition parameters not included in this table cannot be
used.
Table 3.12.1 Welding conditions of WB- W350 / W400
Welding condition
c
DC pulsed
DC wave
pulsed
AC pulsed
AC wave
pulsed
AS
Welding process
○
※１
○
※１
○
※１
○
※１
Current cond. ○ ○ ○ ○
RS control
○
※２
○
※２
○
※２
○
※２
Welding current / Wire speed ○ ○ ○ ○
Welding voltage / Arc length tun.
○ ○ ○ ○
Welding speed
○ ○ ○ ○
Pulse arc characteristic
○ ○
○ ○
EN adjust
― ― ○ ○
Slope time / Slope distance
○ ○ ○ ○
Initial current / Ini. wire speed
○ ○
○ ○
Initial voltage / Ini. arc length
○ ○
○ ○
Wave frequency
― ○
― ○
Start adjust cur.
○ ○
○ ○
Start sdjust time ○ ○ ○ ○
DC pulse Start time ― ― ○ ○
AE
Welding process ○
※１
○
※１
○
※１
○
※１
Current cond. ○ ○ ○ ○
Welding current / Wire speed ○ ○ ○ ○
Welding voltage / Arc length tun. ○ ○ ○ ○
Crater time ○ ○ ○ ○
Post flow time ○ ○ ○ ○
Pulse arc characteristic ○ ○ ○ ○
EN adjust
― ―
○ ○
Slope time / Slope distance
○ ○
○ ○
Robot stop time
○ ○
○ ○
Wave frequency
― ○
― ○
Burnback adj. V. ○ ○ ○ ○
Burnback adj. T. ○ ○ ○ ○
Burnback delay T ○ ○ ○ ○
End pls curr. ○ ○ ○ ○
End pls time ○ ○ ○ ○
○: Can be used
―: Cannot be used.
*1: The welding mode displayed on the robot controller may be different from the welding mode
of the Welbee Inverter welding power source. For details, see "3.4.2 Configuring the welding
mode for the Welbee Inverter series welding power source".

Daihen OTC Almega AX Series Specifications

General

Brand	Daihen
Model	OTC Almega AX Series
Category	Welding Accessories
Language	English