Daihen OTC Almega AX Series User Manual

3.8 Welding conditions of WB-M350L/M400L
3-27
POINT
In the case where the automatic necking sensitivity adjustment is not
performed
In the case of corresponding to the welding conditions shown in Table 3.8.3,
automatic adjustment isn’t applied. The fixed adequate conditions in the
welding power source are applied.
Table 3.8.3 Field where automatic necking sensitivity adjustment is not performed
Welding mode
Current setting value
Wire material
Gas
Wire diameter
Mild steel solid
CO2
0.8, 0.9, 1.0, 1.2
300A or over
MAG
0.8, 0.9, 1.0, 1.2
3.8.4 About the welding constants
The welding constants that can be set when WB-M350L/M400L is connected using the interface
are shown in Table 3.8.4. Welding constants not included in this table cannot be used.
Table 3.8.4 Welding constants of WB-M350L
Item
Welding power source
registration
DL(S1)
DL(S2)
Inching/Retract speed
○ ○
Inching/Retract Key operation
○ ○
Gas check operation
○ ○
Preflow time
○ ○
Arc outage detect time
○ ○
Online modification cycle
○ ○
Auto. storing for online mod.
○ ○
Arc start failure detect time
○ ○
Arc start timing adjust time
○ ○
Arc start retry number
○ ○
Wire retract time
○ ○
Scratch start
○ ○
Waiting time after welding starts
○ ○
Arc end timing adjustment time
○ ○
Wire stick check
○ ○
Wire stick release time
○ ○
WIF timeout check
○ ○
Restart retract distance
○ ○
Arc monitor display cycle
○ ○
Arc monitor sample data num
○ ○
Welding curr./volt. fail. act.
○ ○
Welding current failure limit
○ ○
Welding voltage failure limit
○ ○
Wire feed load fail action
○ ○
Wire feed load fail rate
○ ○
Stop welder at END
○ ○
WIF timeout check adjust.
○ ○
Turbo start
○ ○
Arc outage detect. time (Arc End)
○ ○
○: Can be used.

Daihen OTC Almega AX Series Specifications

General

Brand	Daihen
Model	OTC Almega AX Series
Category	Welding Accessories
Language	English