Daihen OTC Almega AX Series User Manual

4.3 Errors of Welbee Inverter series welding power source
4-4
4.3 Errors of Welbee Inverter series welding power source
This section describes the errors detected by the Welbee Inverter series welding power source.
4.3.1 Error code list
When using a Welbee Inverter series welding power source to connect to a robot, refer to table
Table 4.3.1 that shows the error codes in the front p
anel and on the teach pendant of the robot.
Table 4.3.1 Error code list of Welbee Inverter series welding power source
Digital meter
Left Right
Contents of error
Error code of
supporting
robots
*4
Error
display
release
method
*3
E- 41 Panel communication error A5023 (3)
E- 100
E- 110
Control power supply error A5039 (3)
E- 150 Input over voltage A5023 (3)
E- 160 Shortage of input voltage A5023 (3)
E- 200 Primary current detection error A5040 (3)
E- 210 Error in the arc voltage detection A5030 (1)
E- 215
Error in the arc voltage detection
(RS Control)
A5097 (1)
E- 220 Primary side main circuit error A5023 (3)
E- 230 Primary driver error A5023 (3)
E- 240
Secondary current detection
error
A5040 (3)
E- 250 Secondary side main circuit error A5023 (3)
E- 260
Error in the output voltage
detection circuit
A5039 (3)
E- 300
E- 301
E- 302
E- 303
Thermal overload A5026 (3)
E- 310
E- 311
E- 312
Cooling fan error A5023 (3)
E- 500 Lack of water pressure
For
DM/DM(S-2)/DR
/DP/DPR
A5023
For DL/DL(S-2)
A5036
(2)
E- 615 Memory backup error - (1)
E- 700
Secondary side output over
current error
A5025 (1)
E-
710 Lack of phase error A5028 (3)
E-
800
E-
801
Encoder in the wire feeder error A5032 (1)
E- 810
Thermal overload in the governor
circuit
A5042 (1)

Daihen OTC Almega AX Series Specifications

General

Brand	Daihen
Model	OTC Almega AX Series
Category	Welding Accessories
Language	English