Daihen OTC Almega AX Series User Manual

Chapter 2 Connections
This chapter describes how to connect the Welding Interface (Digital).
2.1 Connect Welding Interface (Digital) ............................................................2-1
2.1.1 Installation of the Welding Interface (Digital) Board .............................2-1
2.1.2 Connection of Control cable 5 (Robot controller side)..........................2-3
2.1.3 Connection of Control cable 5 (Welding power source side)................2-4
2.1.4 Connection of Control cable 4..............................................................2-5
2.1.5 Connection of Workpiece side welding cable / Torch side welding
cable..................................................................................................2-5
2.1.6 Connection of Gas hose ......................................................................2-5
2.1.7 Connection of Voltage detecting cable (workpiece side)
(for WB-M350L/WB-P350L/WB-P400L/WB-P500L) ........................2-6
2.2 Electrical connection diagram.....................................................................2-8

Daihen OTC Almega AX Series Specifications

General

Brand	Daihen
Model	OTC Almega AX Series
Category	Welding Accessories
Language	English