3.13 Welding conditions of WB-A350P/A500P
3-59
3.13.5 About the welding constants
The welding conditions that can be set when WB-A350P/500P is connected using the interface
are shown in Table 3.13.4. Welding condition parameters not included in this table cannot be
used.
Table 3.13.4 Welding conditions of WB-A350P/500P
Item
Inching/Retract speed
Inching/Retract Key operation
Gas check operation
Preflow time
Arc outage detect time
Online modification cycle
Auto. storing for online mod.
Arc start failure detect time
Arc start timing adjust time
Scratch start
Arc end timing adjustment time
WIF timeout check
Restart retract distance
Arc monitor display cycle
Arc monitor sample data num
Welding curr/volt fail act.
Welding current failure limit
Wire retract on stop
Electrode short error
Electrode short check voltage
Wire feed load fail action
Wire feed load fail rate
Stop welder at END
WIF timeout check adjust
Torch
To Next Page
Loading...
Need help?
General
