Daikin Altherma 3 GEO - Menu Structure: Overview Installer Settings

6 Configuration
Installation manual
35
EGSAH/X06+10UDA9W
Daikin Altherma 3 GEO
4P598591-1A – 2019.12
NOTICE
The Brine freezing temperature setting can be
modified and read out in [9.M].
After changing the setting in [9.M] or in the field settings
overview [9.I], wait 10 seconds before restarting the unit
via the user interface to ensure that the setting is saved in
the memory correctly.
This setting can ONLY be modified if the communication
between hydro module and compressor module is present.
The communication between hydro module and
compressor module is NOT guaranteed and/or applicable
if:
▪ error "U4" appears on the user interface,
▪ the heat pump module is connected to preferential kWh
rate power supply where power supply is interrupted
and preferential kWh rate power supply is activated.
6.5 Menu structure: Overview installer settings
[9]
Installer settings
Configuration wizard
Domestic hot water
Backup heater
Emergency
Balancing
Water pipe freeze prevention
Benefit kWh power supply
Power consumption control
Energy metering
Sensors
Bivalent
Alarm output
Auto restart
Power saving function
Disable protections
Overview field settings
Forced defrost
Brine freezing temperature
[9.2] Domestic hot water
Domestic hot water
DHW pump
DHW pump schedule
Solar
[9.3] Backup heater
Backup heater type
Voltage
Configuration
Maximum capacity
Equilibrium
Equilibrium temperature
Operation
[9.6] Balancing
Space heating priority
Priority temperature
Minimum running timer
Anti-recycle timer
Maximum running timer
Additional timer
[9.8] Benefit kWh power supply
Benefit kWh power supply
Allow heater
Allow pump
[9.9] Power consumption control
Power consumption control
Type
Limit
Limit 1
Limit 2
Limit 3
Limit 4
Priority heater
Current sensor offset
BBR16 activation
BBR16 power limit
(*)
[9.A] Energy metering
Electricity meter 2
Electricity meter 1
[9.B] Sensors
External sensor
Ext. amb. sensor offset
Averaging time
[9.C] Bivalent
Bivalent
Boiler efficiency
Temperature
Hysteresis
(*)
INFORMATION
Depending on the selected installer settings and unit type,
settings will be visible/invisible.