Daikin Altherma EKWHCTRL1 - EKPCBO Selector Operations; 5.1 On-board Speed Selector Overview

18
S
U
I
A
B
mode
o
A
A
B
5.1
5.2
5.3
On-board speed selector for connecting to standard thermostat
LED indications
The command is for switching on and off and selecting the
4 speeds directly from the fan coil.
Switching on and off takes place via closing of the external
thermostat contact.
The control panel has a memory, so settings will not be lost
if the appliance is switched off or in the power supply is cut.
Controls cannot be installed on the FWXM-series.
After 20 seconds from the last action, the LED brightness
will be reduced for improved night-time comfort. Press
any key to restore maximum brightness.
The 5 LEDs display the operational states:
Minimum speed selected
Medium speed selected
Maximum speed selected
Supersilent function selected
Fan coil off or TA contact open (flashing)
Warning Led
speed selection key
EKPCBO
General On Switch
To manage the fan coil via the selector, it must be
connected to the mains and to a room thermostat with a
single 230V AC contact.
If a general switch is installed on the power line, this must
also be switched on.
- Turn the device on by activating the general switch