What to do if my Daikin ARXM71N2V1B9 has water leakage?
If you notice water leakage from your Daikin Air Conditioner, there are a couple of potential causes: * Incomplete thermal insulation of gas and liquid piping, including indoor portions of the drain hose extension. Ensure the thermal insulation of the piping and the drain hose is complete. * Improperly connected drainage. Make sure to secure the drainage.
What to do if my Daikin ARXM71N2V1B9 Air Conditioner unit does NOT function or shows burn damage?
If your Daikin Air Conditioner unit isn't functioning or shows signs of burn damage, the wiring may not have been performed according to specifications. Correct the wiring to resolve this issue.
How to fix Daikin ARXM71N2V1B9 indoor units that fall, vibrate or make noise?
If the indoor units of your Daikin Air Conditioner are falling, vibrating, or making noise, ensure that you install them securely.
What to do if my Daikin ARXM71N2V1B9 has electrical leakage?
If you're experiencing electrical leakage with your Daikin Air Conditioner, it's likely that the unit isn't earthed correctly. Check and correct the connection of the earth wiring.
General| Model | ARXM71N2V1B9 |
|---|---|
| Cooling Capacity | 7.1 kW |
| Heating Capacity | 8.0 kW |
| Energy Efficiency Ratio (EER) | 3.21 |
| Refrigerant | R32 |
| Indoor Unit Dimensions (HxWxD) | 295x990x263 mm |
| Inverter | Yes |
| Power Supply | 220-240 V, 50 Hz |
| Type | Split System Air Conditioner |
Key safety rules for installers, including site, refrigerant, and electrical precautions.
Specific safety warnings and precautions for handling R32 refrigerant.
Guidelines for selecting and preparing the optimal installation location for the unit.
Requirements for refrigerant piping, insulation, and electrical wiring preparation.
Steps for mounting, drainage, and connecting refrigerant piping.
Procedures for leak testing, vacuum drying, and charging refrigerant.
Connecting the power supply and communication wiring to the outdoor unit.
How to set up facility mode and standby electricity saving.
Pre-checks, test runs, and final system startup procedures.
Safety precautions and schedule for unit maintenance.
Methods for diagnosing and resolving common unit problems using symptoms and LEDs.
Essential technical diagrams for installation and reference.
Definitions of key terms used in the manual.
To Next Page
