Quick reference
7
BRC2E52C7+BRC3E52C7
Wired remote controller
4P368040-1 – 2014.02
Installation
The detailed Installation and Operation Manual are available on http:/
/www.daikineurope.com/support-and-manuals/product-information/.
1. General safety precautions
Please read these "General safety precautions" carefully before
installing the remote controller.
Improper installation or attachment of equipment or accessories
could result in electric shock, short-circuit, leaks, fire or other damage
to the equipment or personal injury.
If unsure of installation procedures or use, always contact your dealer
for advice and information.
Do NOT install the remote controller by yourself. Improper installation
may result in electric shocks or fire. Consult your Daikin dealer.
After completing the installation:
conduct a trial operation to check for faults,
explain the customer how to operate the air conditioner with the
aid of the Operation part of this Quick Reference,
ask the customer to store the quick reference for future
reference.
2. What is in the box
1 Remote controller (upper and lower part)
2 Wood screws+wall plugs
3 Small screws
4 Clamp
5 Wiring retainer
3. Fasten the remote controller
1 Wall mounting, fasten with the 2 included wood screws
(Ø3.5×32) and plugs.
2 Switchbox mounting, fasten with the 2 included small
screws (M4×16).
For the field supplied switchbox, use optional accessory KJB111A or
KJB211A.
4. Wire the indoor unit
4 methods:
1 from the rear,
2 from the left,
3 from the top,
4 from the top center.
WARNING
Carefully read these instructions before installation. They
will tell you how to install, how to configure and how to use
the unit properly. Keep this manual in a handy place for
future reference.
This is an option to be used in combination with Daikin
units. Refer to the Installation and Operation Manual of the
units for installation and operation instructions.
WARNING
All field wiring and components must be installed by an
installer and must comply with the applicable legislation.
NOTICE
When the thermo function of the remote controller is used,
select the installation location while considering it should
be a place:
where the average temperature in the room can be
detected,
which is not exposed to direct sunlight,
which is not near a heat source,
which is not affected by the outside air or air draught
due to, for example, opening/closing of doors or the
like,
where the front panel and the display are kept clean,
where the temperature is between –10°C and 50°C,
where the relative humidity is max. 95%.
NOTICE
Do NOT install the remote controller:
Near machinery emitting electromagnetic radiation.
Electromagnetic radiation may disturb the operation of
the control system and result in a malfunction of the
unit.
In moist areas or places where it may be exposed to
water. If water enters the remote controller, electric
shocks may be caused and the inner electronics may
fail.
WARNING
Consult your local dealer regarding relocation and
reinstallation of the remote controller.
INFORMATION
Select a flat surface for installation if possible.
Do not tighten the installation screws too much to
avoid deforming the lower case.
To Next Page
