DC3SEA SERIES
THREE-PHASE
AIR CONDITIONING
INSTALLATION & SERVICE REFERENCE
IMPORTANT SAFETY INSTRUCTIONS
The following symbols and labels are used throughout this
manual to indicate immediate or potential safety hazards.
It is the owner’s and installer’s responsibility to read
and comply with all safety information and instructions
accompanying these symbols. Failure to heed safety
information increases the risk of personal injury, property
damage, and/or product damage.
NOTE: This equipment is approved to use only with R-32
refrigerant.
WARNING
WARNING
CAUTION
WARNING
WARNING
INSTALLATION CLEARANCES
Special consideration must be given to location of the
condensing unit(s) in regard to structures, obstructions,
other units, and any/all other factors that may interfere
with air circulation. Where possible, the top of the unit
should be completely unobstructed; however, if vertical
conditions require placement beneath an obstruction there
should be a minimum of 60 inches between the top of
Ensure there is not a
potential for refrigerant to pool should a leak occur in the
circulation only. Consult all appropriate regulatory codes
consideration in selecting a location for the unit(s) is the
angle to obstructions. Either side adjacent the valves be
placed toward the structure provided the side away from
the structure maintains minimum service clearance. Corner
installations are strongly discouraged.
INSTALLATION INSTRUCTIONS
7/2024
© 2024
19001 Kermier Rd. Waller, TX 77484
To Next Page
Need help?
General