Power failure. Press Enter button to start the Unit.
Unit is off due to external temperature below ambient
lockout threshold.
Unit is verifying the flow switch status before
temperature control start.
Waiting for thermal load on water circuit.
No compressor available (both off or in conditions
that inhibits their start).
Unit is working in Fan Silent Mode.
Unit is off from local switch.
Unit is in idle after a Cool/Heat switch.
Compressor is off due to unit alarm.
Compressor is ready but the Unit is off.
Compressor is off from switch.
Automatic compressor load management.
Manual compressor load management.
Compressor is off due to Oil Heating.
Compressor is ready to start.
Compressor is waiting for safety timers to expire
before it could be kicked again.
Compressor is off from terminal.
Compressor is in pre-emptying evaporator before it
could be automatically managed.
Compressor is pre-emptying the evaporator before
shut-down.
Compressor is reaching its minimum load
percentage.
Discharge superheat is lower than a adjustable
threshold
Compressor is in defrosting procedure.
Automatic compressor load management (Inverter).
Maximum absorbed current reached compressor
cannot load.
Compressor is off from Remote Supervisor.
To Next Page
Loading...
