9
Replacement
• Remove the tabs on the filter frame and
replace with a new filter.
Dispose of the old filter as flammable waste.
6. Attach the air pulifying filter with photocata-
lytic deodorizing function and the air filter.
Once cleaning is done be sure to replace the air
filter as it was.
7. Press the FILTER RESET button on the
remote controller.
The display “ ”(TIME TO CLEAN AIR FIL-
TER) vanishes.
HOW TO CLEAN THE AIR OUTLET AND
EXTERIOR
• Clean with soft cloth.
• When it is difficult to remove stains, use water or
neutral detergent.
NOTE
• Do not use gasoline, benzene, thinner, polishing
powder, liquid insecticide. It may cause discolor-
ing or warping.
• Do not use water or air of 50°C or higher for clean-
ing air filters.
HOW TO CLEAN THE FRONT PANEL
You can remove the front panel to clean it.
NOTES
• Hold the front panel firmly so that it does not fall.
• Do not use water over 50 °C, benzine, gasoline,
thinner, or other volatile substances, polishing
powder, or hard scrub brushes to clean the panel.
• Make sure the front panel is solidly in place.
1. Open the front panel.
Place your fingers on the panel protrusions on
the left and right sides of the main unit and open
until the panel stops.
2. Remove the front panel.
Push the axes on either side of the front panel
towards the center of the main unit and remove.
(
You can also remove it by sliding the front panel
either to the left or right and pulling it forward.
)
3. Clean the front panel.
• Wipe gently with a soft wet cloth.
• Only use neutral cleaning agents.
• After washing off, wipe off any excess water
and dry in a shaded location.
4. Attach the front panel.
Set the keys of the front panel into the slots and
push them in all the way.
Close the front panel slowly in this state.
START UP AFTER A LONG STOP
Confirm the following
• Check that the air inlet and outlet are not blocked.
Remove any obstacle.
• Check if the earth is connected.
Might there be a broken wire somewhere?
Contact your dealer if there are any problems.
Clean the air filter and outside panels
• After cleaning the air filter, make sure to attach it.
Turn on the main power supply switch
• The display on the remote controller will be shown
when the power is turned on.
• To protect the unit, turn on the main power switch
at least 6 hours before operation.
01_EN_3P141308-4F.fm Page 9 Thursday, October 13, 2005 3:02 PM
To Next Page
Loading...
Need help?
General
