6
NOTE
• The setting temperature range of the remote con-
troller is 16°C to 32°C.
FAN SPEED CONTROL
Press FAN SPEED CONTROL button.
High or Low fan speed can be selected.
The microchip may sometimes control the fan speed
in order to protect the unit.
AIR FLOW DIRECTION ADJUST
• There are 2 ways of adjusting the air discharge
angle.
A. UP AND DOWN DIRECTION
Press the AIR FLOW DIRECTION ADJUST
button to select the air direction as follow-
ing.
The AIR FLOW FLAP display
swings as shown below and the
air flow direction continuously
varies. (Automatic swing set-
ting)
Press AIR FLOW DIRECTION
ADJUST button to select the air
direction of your choice.
The AIR FLOW FLAP display
stops swinging and the air flow
direction is fixed (Fixed air flow
direction setting).
A. Up and down adjustment
B. Left and right direction
swing
MOVEMENT OF THE AIR FLOW FLAP
For the following conditions, micro computer con-
trols the air flow direction so it may be different from
the display.
NOTE
•
If you try cooling or programmed drying, while the
flaps are facing downward, air flow direction may
change unexpectedly. There is nothing wrong with
the equipment. This serves to prevent dew formed
on parts in the air discharge outlet from dripping.
• Operation mode includes automatic operation.
We recommend using the fan in the position listed
above when fixing the fan direction.
B. LEFT AND RIGHT DIRECTION
Hold the tabs on edge louvers (horizontal fan direc-
tion adjustment flaps) down slightly and adjust left
and right to match the room conditions or your pref-
erence.
Operation
mode
Cooling Heating
Operation
conditions
• When operat-
ing continu-
ously at
downward air
flow direction
• When room
temperature is
higher than the
set temperature
•
At defrost
operation
(The flaps blow
horizontally to
avoid blowing
cold air directly
on the occupants
of the room.)
Recommended flap positions
Cooling
Heating
01_EN_3P141308-4F.fm Page 6 Thursday, October 13, 2005 3:02 PM
To Next Page
Loading...
Need help?
General
