Daikin FFA60RV1A - Emergency Stop and Malfunction Codes; Troubleshooting Emergency Stops; Reading Malfunction Codes; Emergency Stop Troubleshooting Steps

II. EMERGENCY STOP
When the air conditioner stops in
emergency, the OPERATING INDICATOR
LAMP on the indoor unit starts blinking.
Take the following steps yourself to read
the malfunction code that appears on the
display. Contact your local dealer with this
code. It will help pinpoint the cause of the
trouble, speeding up the repair.
1
3 5
7
2 4
6
1
Press the INSPECTION button to select
the inspection mode “
”.
“ ” appears on display and blinks.
“UNIT No.” appears.
2
Press PROGRAMMING TIMER button and
change the unit number.
Press to change the unit number until the indoor
unit beeps and perform the following operation
according to the number of beeps.
Number of beeps
3 short beeps ���� Perform all steps from
3
to
6
.
1 short beep ��� Perform
3
and
6
steps.
1 long beep ��� Normal state
3
Press OPERATION MODE SELECTOR
button.
“ ” on the left-hand of the malfunction code
blinks.
4
Press PROGRAMMING TIMER button and
change the malfunction code.
Press until the indoor unit beeps twice.
5
Press OPERATION MODE SELECTOR
button.
“
” on the right-hand of the malfunction code
blinks.
6
Press PROGRAMMING TIMER button and
change the malfunction code.
Press until the indoor unit makes a long beep.
Themalfunctioncodeisxedwhentheindoor
unit makes a long beep.
7
Reset of the display
Press the OPERATION MODE SELECTOR
button to get the display back to the
normal state.
[Trouble]
The OPERATING INDICATOR LAMP of the
indoorunitisashingandtheunitdoesnotwork
at all. (Refer to page 3)
Malfunction
Code
INSPECTION display
Unit No.
which
sensed
trouble
English 12
02_EN_3P477582-1.indd 12 6/15/2017 15:17:42