SiBE121135 RA Indoor Unit
Operation Manual 127
2.1.2 Name of Parts
FTXG25/35/50JV1BW(A)
Name of Parts
Indoor Unit
Air outlet
Louvers (vertical blades)
Orange
Blue
3 min.
5 sec. 5 sec.
2 sec. 2 sec. 2 sec.
Green
Blue
Red
White
Off
• Appearance of the indoor unit may differ.
Front panel
• The louvers are inside of the air outlet.
Flaps (horizontal blades)
Model name
plate
Panel tab
• It detects the air temperature
around the unit.
Room temperature
sensor
• It detects the movements of
people and automatically
switches between normal
operation and energy saving
operation.
INTELLIGENT EYE
sensor
Air inlet
INTELLIGENT EYE lamp
(green)
Signal receiver and Indoor
unit ON/OFF switch
• It receives signals from the remote
controller.
• When the unit receives a signal, you will
hear a beep sound.
Signal receiver
Sound type
beep-beep
beep
long beep
Indoor unit ON/OFF switch
• Press this switch once to start operation.
Press once again to stop it.
• The operation mode refer to the following table.
Temperature setting
25˚C
Airflow rate
AUTO
• This switch is useful when the remote controller is
missing.
Orange
Orange
Orange
Orange
Orange
TIMER lamp colour
TIMER lamp colour : For COOL
TIMER lamp
• When operation by timer has been set, the multi-monitor lamp
periodically changes to orange. After lighting orange for about
5 seconds, it returns to the colour of the operation mode.
The multi-monitor lamp will turn orange on and off in cyclic
manner while the air conditioner is not in operation.
Operation
AUTO
DRY
COOL
HEAT
FAN
TIMER
Multi-monitor lamp
Red/Blue
Green
Blue
Red
White
Orange
• The lamp colour changes according to
the operation.
Multi-monitor lamp
Multi-monitor lamp and
TIMER lamp
Display
Mode
AUTO
Case
Operation start
Setting changed
Operation stop
DRY :
COOL :
HEAT :
FAN :
Stop :
To Next Page
Loading...
