RA Indoor Unit SiBE121135
230 Operation Manual
To combine ON TIMER and OFF TIMER
• A sample setting for combining the two timers is shown below.
ATTENTION
C
TEMP
2
1, 3
4
(Example)
Combined
To cancel ON
TIMER operation
To use ON TIMER operation
• Check that the clock is correct. If not, set
the clock to the present time
1. Press “ON TIMER button”.
is displayed.
blinks.
2. Press “TIMER Setting button”
until the time setting reaches
the point you like.
• Every pressing of either button
increases or decreases the time setting
by 10 minutes. Holding down either
button changes the setting rapidly.
3. Press “ON TIMER button”
again.
•
The TIMER lamp lights up.
4. Press “CANCEL button”.
• The TIMER lamp goes off.
Present time: 11:00 p.m.
(The unit operating)
OFF TIMER at 0:00 a.m.
ON TIMER at 7:00 a.m.
In the following cases, set the timer again.
• After a breaker has turned OFF.
• After a power failure.
• After replacing batteries in the remote controller.
To Next Page
Loading...
