Daikin FT60GAVE - User Manual

Questions and Answers

S
Sherri FernandezAug 7, 2025
Why is my Daikin Air Conditioner cooling so poorly?
- M
  Michael YoungAug 7, 2025
  If your Daikin Air Conditioner isn't cooling well, several factors could be the cause. First, ensure the air filters are clean. Check that nothing is blocking the air inlet or outlet of either the indoor or outdoor units. Verify that the temperature setting is appropriate for the room size and your desired level of coolness. Also, make sure all windows and doors are properly closed to prevent warm air from entering. Finally, check that the airflow rate and direction are set correctly to optimize cooling.
B
Benjamin WilsonAug 13, 2025
How to fix a Daikin FT60GAVE that won't turn on?
- E
  Emily FrancisAug 13, 2025
  If your Daikin Air Conditioner isn't turning on and the OPERATION lamp is off, check the following: * Has a breaker tripped or a fuse blown? * Is there a power failure in your area? * Are the batteries correctly installed in the remote controller? * Is the timer setting correct?
J
Jeffery WilsonAug 19, 2025
What to do if Daikin FT60GAVE is leaking water inside?
- M
  Michael JacobsAug 19, 2025
  If water is leaking from the indoor unit of your Daikin Air Conditioner, turn the breaker OFF and call the service shop.
E
Erica MatthewsAug 26, 2025
What to do if my Daikin FT60GAVE Air Conditioner smells like burning?
- J
  jmartinezAug 26, 2025
  If you notice a burning smell coming from your Daikin Air Conditioner, immediately turn the breaker OFF and contact the service shop for assistance.
C
Christopher PaceAug 31, 2025
What to do if my Daikin FT60GAVE Air Conditioner stops and the operation lamp blinks?
- Q
  qriosAug 31, 2025
  If your Daikin Air Conditioner suddenly stops and the OPERATION lamp is blinking, it indicates a potential issue. Start by checking and cleaning the air filters. Also, ensure that nothing is blocking the air inlet or outlet of the indoor and outdoor units. After clearing any obstructions and cleaning the filters, turn the breaker OFF, then turn it back ON. Try operating the air conditioner again using the remote controller. If the lamp continues to blink after these steps, it is recommended to call the service shop where you purchased the unit.