Daikin FTKD50JVET - Adjusting Airflow Direction and Comfort; Implementing 3 D Airflow

11
Adjusting the Air Flow Direction
You can adjust the air flow direction to increase
your comfort.
Adjusting the
horizontal blade (flap)
....... To stop the flap at an
angle you like, press
SWING
.
● When [SWING] is
selected, the flap
swinging range depends
on the operation mode.
(See the figure.)
● When [SWING] is
selected in heating
operation, the flap and
the diffuse swing up and
down in combination.
● The diffuser is kept open
in DRY or COOL mode.
Press
SWING
.
● Every time the button is pressed, “ ”
appears or disappears.
....... The flap automatically
swings up and down.
ATTENTION
● Always use a remote controller to adjust
the flap angle. If you attempt to move it
forcibly with hand when it is swinging,
the mechanism may be broken.
Notes on flap angles
Adjusting the
vertical blade (louvre)
Press .
● Every time the button is pressed, “ ”
appears or disappears.
....... The flap automatically
swings up and down.
....... To stop the flap at an
angle you like, press .
DRY⋅COOL
HEAT
NOTE
Unless [SWING] is selected, you should
set the flap at a downward angle in HEAT
mode and at a nearhorizontal angle in
COOL or DRY mode to obtain the best
performance.
3-D air flow
The 3-D air flow function controls the air flow by
alternating the horizontal swing (up and down)
and vertical swing (left and right).
This provides good air circulation throughout
the room and reduces temperature fluctuations.
Press
SWING
and during the air
conditioner is operating.
■■
■■
■ To cancel 3-D air flow:
Press
SWING
or .
The up/down and left/right
swing displays on the remote
controller will move.
01EN3P059682-3R.p65 07/05/26, 17:08Page 11 AdobePageMaker6.5J/Win