Need help?Do you have a question about the Daikin FTWN35JV1 and is the answer not in the manual?
General| Model | FTWN35JV1 |
|---|---|
| Cooling Capacity | 3.5 kW |
| Heating Capacity | 4.0 kW |
| Power Supply | 220-240V, 50Hz |
| Refrigerant | R32 |
| Type | Wall-mounted |
Disconnect wire fixtures, terminal board, and swing motor connector.
Remove indoor heat exchanger thermistor, drip proof plate, and earth wire.
Remove screws, unfasten hook, disconnect motor connector, and pull out the electrical box.
Release shield plate, thermistor, and earth wire from their respective hooks.
Remove terminal board and signal receiver unit by unscrewing and unfastening hooks.
Remove INTELLIGENT EYE sensor PCB and display PCB by unfastening hooks.
Remove control PCB by unfastening hooks and lifting the bottom part.
To Next Page
