Need help?Do you have a question about the Daikin FTX36WVJU9 and is the answer not in the manual?
General| Model | FTX36WVJU9 |
|---|---|
| Category | Air Conditioner |
| Brand | Daikin |
| Heating Capacity | 4.0 kW |
| Power Supply | 220-240V/50Hz/1Ph |
| Refrigerant | R32 |
| Indoor Unit Weight | 8.5 kg |
| Outdoor Unit Weight | 26 kg |
| Energy Efficiency Ratio (Cooling) | 3.5 |
Explains the meaning of DANGER, WARNING, CAUTION, and NOTE symbols used in the manual.
Covers hazards related to refrigerant gas, grounding, wiring, and power supply.
Addresses risks from installation location, unit handling, protective gear, and operation precautions.
Specifies placement requirements for the indoor unit, considering obstructions, sunlight, drainage, heat, oil vapor, circulation, and interference.
Guides on finding a location for the remote controller signal and configuring jumpers for unit type.
Details steps for hooking the indoor unit's bottom frame onto the mounting plate.
Explains how to release hooks to remove the indoor unit from the mounting plate.
Describes using a tool to release the front grille fixture by turning it 90 degrees.
Outlines the steps to remove the service lid by unscrewing and pulling it out.
Guides on securing the mounting plate to the wall, ensuring it's level and can support the unit's weight.
Instructions for drilling a hole and installing a wall pipe, with a WARNING about metal walls.
Provides steps for connecting pipes and wires for right-side, right-back, or right-bottom installation.
Details how to switch the drain plug/hose and install pipes for left-side, left-back, or left-bottom routing.
Instructions for installing drain hose depth for wall embedded piping.
Provides detailed instructions and warnings for wiring the indoor unit, including terminal connections.
Guides on connecting the drain hose, ensuring proper slope, and extending the hose if necessary.
Steps for cutting, deburring, and flaring pipe ends for refrigerant connections.
Advises on protecting pipes from dust, moisture, and using gentle bends.
Recommends materials and thickness for copper pipes and insulation for HVAC systems.
Instructions for safely removing and reattaching the indoor unit's front panel.
Guides on detaching and reassembling the front grille, including screw covers and fixtures.
Explains how to set different addresses for multiple indoor units using jumpers in the unit and remote controller.
Describes the procedure for connecting to an HA system using accessories and a connection cord.
Details how to perform trial operation for COOL or HEAT modes, including voltage checks and temperature settings.
Lists essential test items to verify during installation, checking for leaks, insulation, grounding, wiring, and unit operation.
To Next Page