Daikin FTXA20A - Page 128

2 | Components
Service manual
128
FTXA20~50A(W)(S)(T) + FTXA20~50B(B)(S)(T) + RXA42+50A +
RXA20~35A(9) + RXA42+50B
Split Stylish R32
ESIE18-03D – 2021.05
a
c
b
a Arm
b Shaft
c Shaft slot
4 Disconnect the front panel shaft from the shaft slot on the left side.
a
c
b
a Arm
b Shaft slot
c Shaft
5 Remove the front panel.
6 To re-install the front panel perform the steps in the opposite order.
To open the service cover
1 Remove 1 screw from the service cover.
2 Pull out the service cover horizontally away from the unit.
a
b
a Service cover screw
b Service cover
To remove the front grille
CAUTION
Wear adequate personal protective equipment (protective gloves, safety glasses,…)
when installing, maintaining or servicing the system.
1 Open the front panel. Refer to "To open the front panel"[4126].
2 Remove the service cover. Refer to "To open the service cover"[4128].
3 Remove the wire harness from the wire clamp and the connector.
4 Remove the flap by pushing it to the left side and towards you.