Daikin FTXA20C2V1BW - Page 14

5 Operation
Operation manual
14
CTXA-C(W)(B)(S) + FTXA-C(W)(B)(S)
Daikin room air conditioner
3P728539-1 – 2023.05
For more information and FAQ, refer to app.daikineurope.com.
Note: Setting is done by the wireless remote control in the wireless
LAN setting menu. During setting, always aim the wireless remote
control at the infrared signal receiver on the unit.
INFORMATION
Make sure operation is stopped before setting the wireless
connection. Connection CANNOT be made when the unit
is in operation.
1 Stop operation before setting the wireless connection.
2 Make sure the wireless router is close enough to the unit and
nothing obstructs the signal.
Menu Description
Connection status check
Connection using WPS button
Connection using SSID and KEY
Reset to factory default
Wireless LAN OFF
To confirm the wireless LAN connection status
1 Hold for at least 5seconds.
Result: The confirmation display (menu ) appears.
2 Press to confirm the selection.
Result: “Beep” sound is heard when the unit receives signal.
3 Check the indoor unit LED.
…lamp is blinking. Status
Timer Communication is OK
Operation and timer Communication is OFF
4 Press to exit the menu.
Result: The display will return to the default screen.
To connect the wireless LAN to your home
network
The wireless adapter can be connected to your home network using
the:
▪ WPS button (Wi-Fi Protected Setup) on the router (if present),
▪ The SSID (Service Set Identifier) and the KEY (password) -
located on the unit.
To connect using the WPS button
1 Hold for at least 5seconds in the default screen.
Result: The confirmation display (menu ) appears.
2 Press repeatedly or until the WPS setting display
(menu ) appears.
3 Press to confirm the selection.
Result: “Beep” sound is heard when the unit receives signal.
4 Press the WPS button on your communication device (e.g.
router) within approximately 1 minute. Refer to the manual of
your communication device.
INFORMATION
If the connection with your router is not possible, try
procedure "To connect using SSID and KEY
number"[414].
5 Press to exit the menu.
Result: The display will return to the default screen.
To connect using SSID and KEY number
1 Hold for at least 5seconds in the default screen.
Result: The confirmation display (menu ) appears.
2 Press repeatedly or until the AP mode display (menu
) appears.
3 Press to confirm the selection.
Result: “Beep” sound is heard when the unit receives signal.
4 Connect your smart device to the access point in the same way
as to a standard wireless network.
5 Enter the SSID number and password located on the unit or in
the accessory set.
6 Open the Daikin Online Controller application and follow the
steps on the screen.
Result: Wireless adapter mode will automatically change from
the AP mode to the RUN mode, the timer LED is blinking.
7 Press to exit the menu.
Result: The display will return to the default screen.
To reset the connection setting to the factory
default
Reset the connection setting to the factory default in case you want
to:
▪ switch between the WPS and the AP connection option,
▪ disconnect the Wi-Fi adapter and the communication device (e.g.
router) or smart device,
▪ repeat the setting if the connection was unsuccessful.
1 Hold for at least 5seconds in the default screen.
Result: The confirmation display (menu ) appears.
2 Press repeatedly or until the menu appears.