Daikin FTXC20BV1B - Preparation before Operation

1-8
SWIN
LED
CANCEL CLOCK
CANCEL
OFF
ECO+
ON
ON/
SLEE
TEMP
SWIN
LED
CANCEL CLOCK
CANCEL
OFF
ECO+
ON
ON/
SLEE
TEMP
MODE
FAN
POWERFU
QUIE
MODE
FAN
POWERFU
QUIE
Preparation Before Operation
 To operate the remote controller
• Aim the transmitter of the remote controller at the
receiver of the indoor unit.
• Ensure there is no blockage such as curtain
between the indoor unit and the remote controller,
signal transmission will be unsuccessful.
• The maximum distance for successful
communication is about 7m.
 To fix the remote controller holder
on the wall
1. Choose a location where signal is able to reach the unit.
2. Fix the holder onto a wall, a pillar or etc with the screws
supplied with the holder.
3. Place the remote controller on the holder.
 About remote controller
• Do not drop nor wet the remote controller.
• Never expose the remote controller under direct sunlight.
• Dust on the transmitter lense cover will reduce the sensitivity.
• Signal communication may be affected if the air conditioner is being installed near an electronic-
starter-type fluorescent lamp (such as inverter-type lamp) in the room.
Receiver