What to do if an abnormal functioning happens during operation of Daikin Air Conditioner?
If your Daikin Air Conditioner is functioning abnormally during operation, try turning the breaker off, then turning it back on. Afterward, try operating the air conditioner using the remote controller.
What to do if my Daikin FTXM25M2V1B Air Conditioner does not turn on?
If your Daikin air conditioner isn't turning on, check the following: * Has a breaker tripped or a fuse blown? * Is there a power failure in your area? * Are the batteries correctly installed in the remote controller? * Is the timer setting correct?
Why is my Daikin Air Conditioner outdoor unit emitting water or steam?
The outdoor unit may emit water or steam for these reasons: * In HEAT operation: The frost on the outdoor unit melts into water or steam when the air conditioner is in defrost operation. * In COOL or DRY operation: Moisture in the air condenses into water on the cool surface of outdoor unit piping and drips.
Why is my Daikin FTXM25M2V1B remote controller not working properly?
If your Daikin Air Conditioner's remote controller isn't working correctly, the batteries might be low. Try replacing them with new AAA.LR03 alkaline batteries.
Why is the cooling (heating) effect poor in my Daikin FTXM25M2V1B Air Conditioner?
If your Daikin Air Conditioner isn't providing sufficient cooling or heating, consider these potential causes: * Check if the air filters are clean. * Make sure nothing is blocking the air inlet or outlet of either the indoor or outdoor units. * Verify that the temperature setting is appropriate. * Ensure all windows and doors are closed. * Confirm the air flow rate and direction are properly set.
Why does mist come out of the indoor unit of my Daikin FTXM25M2V1B Air Conditioner?
If you notice mist coming out of the indoor unit of your Daikin Air Conditioner, it could be due to the air in the room being cooled into mist by the cold airflow during COOL operation or cooled by the heat exchanger and becoming mist during defrost operation.
Why Daikin Air Conditioner remote controller does not work properly?
If your Daikin Air Conditioner remote controller isn't working, the batteries might be weak. Replace all batteries with new AAA.LR03 (alkaline) batteries.
Why does the indoor unit of my Daikin Air Conditioner gives out odour?
The odour from the indoor unit of your Daikin Air Conditioner can occur when smells from the room, furniture, or cigarettes are absorbed into the unit and discharged with the airflow. If this persists, it is recommended to have the indoor unit cleaned by a technician. Consult the service shop where you bought the air conditioner.
Why Daikin FTXM25M2V1B Air Conditioner does not operate (OPERATION lamp is off)?
If your Daikin Air Conditioner does not operate and the OPERATION lamp is off, check the following: * Ensure that a breaker hasn’t turned off or a fuse hasn’t blown. * Confirm that there isn’t a power failure. * Verify that batteries are correctly installed in the remote controller. * Make sure the timer setting is correct.
What to do if my Daikin FTXM25M2V1B operation stopped suddenly and the OPERATION lamp flashes?
If your Daikin Air Conditioner operation stopped suddenly and the OPERATION lamp is flashing, take these steps: * Ensure the air filters are clean and clean them if necessary. * Check for any obstructions blocking the air inlet or outlet of the indoor and outdoor units. * Turn the breaker off, remove any obstacles, and then turn it back on. Try operating the air conditioner with the remote controller again. If the lamp continues to flash, contact the service shop where you purchased the air conditioner.
General| Brand | Daikin |
|---|---|
| Model | FTXM25M2V1B |
| Category | Air Conditioner |
| Language | English |
Detects human movement to optimize operation and save energy.
Schedule up to 4 timer settings daily based on family lifestyle.
Removes airborne allergens and pollutants using streamer technology.
Adjusts airflow direction to prevent direct blowing and enhance comfort.
Reduces outdoor unit noise level for quieter operation.
Essential safety guidelines and warnings for proper unit operation and handling.
Identifies and describes the indoor and outdoor unit components.
Steps for setting up the unit, including battery installation and clock setting.
How to select and operate modes like AUTO, DRY, COOL, HEAT, and FAN.
Guides on controlling airflow direction and fan speed for user comfort.
Features for enhanced comfort and energy saving via airflow control and motion detection.
Explains POWERFUL, ECONO, and QUIET operations for performance or efficiency.
Details on the FLASH STREAMER air purification system.
How to set OFF, ON, and WEEKLY timers for automatic operation.
Information for multi-system setups, including priority room settings and operation modes.
Instructions for cleaning and maintaining indoor/outdoor units and filters.
Addresses common problems like no operation, poor cooling, or unusual sounds.
Interpreting error codes from the remote controller and outdoor unit LED indicators.
To Next Page
