Care and Cleaning
CAUTION
Before cleaning, be sure to stop the operation and turn the breaker OFF.
Units
Indoor unit, Outdoor unit and Remote controller
Wipe them with dry soft cloth.
Front panel
Open the front panel.1.
Hold the panel by the tabs on the two sides and lift it •
unitl it stops with a click.
Remove the front panel.2.
Open the front panel further while sliding it to either •
the left or right and pulling it toward you.
This will disconnect the rotation dowel on one side.
Then disconnect the rotation dowel on the other side
in the same manner.
Clean the front panel.3.
Wipe it with a soft cloth soaked in water.•
Only neutral detergent may be used.•
In case of washing the panel with water, wipe it with dry soft cloth, dry it up in the shade after washing.•
Attach the front panel.4.
Align the rotation dowels on the left and right of the front panel with the slots, then push them •
all the way in.
Close the front panel slowly. (Press the panel at both sides and the center.)•
CAUTION
Do not touch the metal parts of the indoor unit. If you touch those parts, this may cause an injury.•
When removing or attaching the front panel, use a robust and stable stool and watch your steps carefully.•
When removing or attaching the front panel, support the panel securely with hand to prevent it from falling.•
For cleaning, do not use hot water above 104°F(40°C), benzine, gasoline, thinner, nor other volatile oils, polishing compound, scrubbing brushes, •
nor other hand stuff.
After cleaning, make sure that the front panel is securely fi xed.
•
01_EN_3P232717-2C.indd 2401_EN_3P232717-2C.indd 24 12/22/2008 3:58:08 PM12/22/2008 3:58:08 PM
To Next Page
Loading...
