SiBE121123_A Service Check Function
Service Diagnosis 152
3.2.4 BRC7E530W
To find the error code, proceed as follows:
Step Action
1 Press the [Inspection / Test] button to enter the inspection mode. Then the figure 0
blinks on the UNIT No. display.
2 Press the [UP] or [DOWN] button and change the UNIT No. until the receiver of the
remote controller starts to beep.
[Inspection / Test] button
(R14392)
00
0
[UP] button
[DOWN] button
(R15408)
00
1
If you hear... Then...
3 short beeps Follow all steps below.
1 short beep Follow steps 3 and 4. Continue the
operation in step 4 until you hear a
continuous beep. This continuous
beep indicates that the error code
is confirmed.
1 continuous beep There is no abnormality.
To Next Page
Loading...
