11
Timer Operation
●
Check that the clock is correct.
If not, set the clock to the present time. (See page 8.)
Timer functions are useful for automatically
switching the air conditioner on or off at night or
in the morning. You can also use OFF TIMER
and ON TIMER in combination.
●
NIGHT SET MODE
When the OFF TIMER is set, the air
conditioner automatically adjusts the
temperature setting (0.5°C up in COOL) to
prevent excessive cooling (heating) for your
pleasant sleep.
Press
OFF
while the air conditioner
is operating.
Press
CANCEL
.
■■
■■
■ To cancel the timer:
Press
OFF
once again.
Then the TIMER lamp goes off.
Press
TIMER
until the time setting
reaches the point you like.
●
Every pressing of either button increases or
decreases the time setting by 10 minutes. Holding
down either button changes the setting rapidly.
2
3
Then the TIMER lamp
lights up.
AM
is displayed.
blinks.
* Previous time setting
appears on display.
OFF TIMER operation
1
Notes on OFF TIMER
ON TIMER operation
Press
ON
while the air conditioner is
not operating.
Press
ON
once again.
■■
■■
■ To cancel the timer:
Then the TIMER lamp goes off.
● Check that the clock is correct. If not, set the
clock to the present time (See page 8).
1
is displayed.
blinks.
* Previous time setting
appears on display.
2
Press
TIMER
until the time setting
reaches the point you like.
● Every pressing of either button increases
or decreases the time setting by 10
minutes. Holding down either button
changes the setting rapidly.
3
Then the TIMER lamp lights up.
Combining ON TIMER and OFF TIMER
Present time: 11:00 PM
(The unit operating)
OFF TIMER at 0:00 a.m.
ON TIMER at 7:00 a.m.
Combined
(Example)
ATTENTION
■ In the following cases, set the timer again.
● After a breaker has turned OFF.
● After a power failure.
● After replacing batteries in the remote controller.
●
When TIMER is set, the present time is not displayed.
● Once you set ON, OFF TIMER, the time setting is
kept in the memory. (The memory is canceled when
remote controller batteries are replaced.)
● When operating the unit via the ON/OFF Timer, the
actual length of operation may vary from the time
entered by the user. (Maximum approx. 10 minutes)
● A sample setting for combining the two timers
is shown below.
Notes on ON, OFF TIMER
AM
Display
AM
Display
ON
OFF
AM
Display
AM
AM
Display
AM
AM
Display
Press
CANCEL
.
To Next Page
Loading...
Need help?
General
