What to do if my Daikin Fan does not operate?
If your Daikin Fan isn't operating, there are a few potential causes. First, there may be a power failure, or the fuse might need replacement; check the power supply and replace the fuse if necessary. Second, the power plug could be disconnected; ensure it is properly connected. Finally, the delay timer may be set incorrectly; review and adjust the delay timer settings.
Why is the air flow too low in my Daikin FWPMM12AV1?
If the air flow in your Daikin Fan is too low, it could be due to a few reasons. The air filter might be dirty, so try cleaning or replacing it. Also, the air suction and discharge could be clogged, so clear any obstructions. Finally, the regulated temperature might not be high enough, so increase the regulated temperature setting.
How to eliminate bad odor from Daikin FWPMM12AV1 Fan discharge air flow?
A bad odor from your Daikin Fan's discharge air flow may be caused by particles from cigarettes, smoke, perfume, etc., that have adhered to the coil. Clean the coil to remove these odors.
What to do if there is condensation on the front air grille of my Daikin Fan?
Condensation on the front air grille of your Daikin Fan's indoor unit can occur due to air humidity after a long period of operation. Maintain operation and ensure proper humidity control. Also, the set temperature might be too low; increase the temperature setting and operate the unit at high fan speed.
Controller board jumper settings for heatpump and cooling modes.
Setting priority for valve, heat, and fan functions on the controller.
A-weighted sound pressure levels for various models and speeds.
A-weighted sound power levels for various models and speeds.
Noise Criteria (NC) curves showing sound pressure levels by frequency.
Fault indications and troubleshooting actions for the 50WJWXX board.
Fault indications and troubleshooting actions for the W2 board.
Fault indications and troubleshooting actions for the W3 board.
Fault indications and troubleshooting actions for the W3DC board.
Controller board jumper settings for heatpump and cooling modes.
Setting priority for valve, heat, and fan functions on the controller.
A-weighted sound pressure levels for various models and speeds.
A-weighted sound power levels for various models and speeds.
Noise Criteria (NC) curves showing sound pressure levels by frequency.
Fault indications and troubleshooting actions for the 50WJWXX board.
Fault indications and troubleshooting actions for the W2 board.
Fault indications and troubleshooting actions for the W3 board.
Fault indications and troubleshooting actions for the W3DC board.
To Next Page
General