26
CARE
Care and Cleaning
■ Indoor unit and remote controller
1. Wipe them with dry soft cloth.
■ Front panel
1. Open the front panel.
• Slide the two stoppers on the left and right
sides inward until they click.
2. Remove the front panel.
• Remove the string.
• Allowing the front panel to fall forward will
enable you to remove it.
3. Clean the front panel.
• Wipe it with a soft cloth soaked in water.
• Only neutral detergent may be used.
• In case of washing the panel with water, wipe it
with dry soft cloth, dry it up in the shade after
washing.
4. Attach the front panel.
• Insert the front panel into the grooves of the unit
(3 places).
• Attach the string to the right, inner-side of the
front grille.
• Close the front panel slowly.
CAUTION
CAUTION
Before cleaning, be sure to stop the operation and
turn the breaker off.
Units
• Don’t touch the metal parts of the indoor unit. If you touch those parts, this may cause an
injury.
• When removing or attaching the front panel, use a robust and stable stool and watch your
steps carefully.
• When removing or attaching the front panel, support the panel securely with hand to prevent
it from falling.
• For cleaning, do not use hot water above 40°C, benzine, gasoline, thinner, nor other volatile
oils, polishing compound, scrubbing brushes, nor other hand stuff.
• After cleaning, make sure that the front panel is securely fixed.
String
Place front
panel in
grooves.
String
01_EN_3P257979-1A.fm Page 26 Tuesday, March 3, 2015 3:09 PM
To Next Page
Loading...
