28
Care and Cleaning
3-2 Titanium apatite photocatalytic air-purifying filter
The titanium apatite photocatalytic air-purifying filter can be renewed by washing it with
water once every 6 months. We recommend replacing it once every 3 years.
[Maintenance]
3-2-1 Vacuum dusts, and soak in warm water
or water for about 10 to 15 minutes if dirt
is heavy.
• Do not remove the filter from frame when
washing with water.
3-2-2 After washing, shake off remaining
water and dry in the shade.
• Since the material is made out of
polyester, do not wring out the filter when
removing water from it.
[Replacement]
3-2-3 Remove the tabs on the filter frame and
replace with a new filter.
• Do not throw away the filter frame. Reuse
the filter frame when replacing the
titanium apatite photocatalytic air-
purifying filter.
• Dispose of the old filter as non-flammable
waste.
4. Set the air filter and titanium apatite
photocatalytic air-purifying filter as
they were and close the front panel.
• Operation without air filter may result in troubles
as dust will accumulate inside the indoor unit.
NOTE
• Operation with dirty filters:
• To order titanium apatite photocatalytic air-purifying filter contact to the service shop there
you bought the unit.
• Dispose of the old filter as non-flammable waste.
(1) cannot deodorize the air. (2) cannot clean the air.
(3) results in poor heating or cooling. (4) may cause odour.
Item Part No.
Titanium apatite photocatalytic air-purifying filter
(without frame) 1 set
KAF968A42
01_EN_3P257979-1A.fm Page 28 Tuesday, March 3, 2015 3:09 PM
To Next Page
Loading...
