EDUS39-600-F6 Installation
FXAQ-M 33
8. WIRING EXAMPLE AND HOW TO SET THE REMOTE CONTROLLER
8-1 HOW TO CONNECT WIRINGS
• Conduit for power supply wiring
Unscrew and remove the conduit mounting plate from the electric parts box. (Refer to Fig. 20)
Fix a conduit to the plate with a lock nut and reattach them at original position.
• Power supply wiring and ground wiring
Unscrew and remove the service lid.
Thread the power supply wiring and ground wiring through the included insulating tube (short) (7) and secure them
with the included clamp (small) (5). (Refer to Fig. 21)
Connect the power supply wiring and ground wiring to the power supply terminal block (3P).
When doing this, firmly secure using the included clamp (small) (5) according to the figure. (Refer to Fig. 22)
• Transmission wiring and remote controller wiring
Unscrew and remove the service lid.
Thread the remote controller wiring and transmission wiring through the included insulating tube (long) (7) and secure
them with the included clamp (small) (5). (Refer to Fig. 21)
Connect the remote controller wiring and the transmission wiring to the terminal block (6P).
When doing this, tie the remote controller wiring and the transmission wiring using the included clamp (small) (5) and
then firmly secure using the included clamp (small) (5) according to the figure. (Refer to Fig. 22)
Electric parts box
Refrigerant piping
Conduit
Lock nut
Conduit mounting plate
Screw
Fig. 20
Insulating tube (short)
(accessory) (7)
Insulating tube (long)
(accessory) (7)
Clamp small
(accessory) (5)
Power
supply
wiring
Ground
wiring
Clamp small
(accessory) (5)
Transmission
wiring
Remote
controller
wiring
Fig. 21
(1in.)
(1in.)
To Next Page
Loading...
