English 4
6. Turn off the indication “ ” or “Time to clean fil-
ter” displayed on the remote controller after turning
on the power.
The indication can be turned off whether in operation or
at stop.
<In case of BRC1E, BRC1D>
• For details, refer to the operation manual attached to
the remote controller.
<In case of BRC1C>
• Press FILTER SIGN RESET button.
NOTE
• Do not remove the air filter except when cleaning.
Unnecessary handling may damage the filter.
HOW TO CLEAN THE AIR INTAKE GRILLE
1. Open the air intake grille.
Slide the two knobs in the direct of the arrow at the same
time, and then slowly lower the grille downward.
Refer to figure 2 on page [1]
2. Detach the air intake grille.
Unhook the grille from its hold.
Refer to figure 5 on page [1]
3. Clean the suction grille.
Wash with a soft bristle brush
and neutral detergent or water,
and dry thoroughly.
NOTE
• When badly soiled, spray with a typical kitchen cleanser
and let sit for about 10 minutes. Then, wash with water.
• Do not use hot water of 50°C or higher, as doing so may
result in discoloration or deformation.
4. Reattach the air intake grille.
Refer to step 2.
5. Close the air intake grille.
While pressing on the grille, slide the two knobs back into
place.
Refer to figure 4 on page [1]
HOW TO CLEAN AIR OUTLET AND OUTSIDE
PANELS
1. Clean with soft cloth.
2. When it is difficult to remove stains, use water or neutral
detergent.
NOTE
• Do not use gasoline, benzene, thinner, polishing powder,
liquid insecticide. It may cause discoloring or warping.
• Do not let the indoor unit get wet. It may cause an electric
shock or a fire.
• Do not use hot water of 50°C or higher, as doing so may
result in discoloration or deformation.
4. SOUND PRESSURE LEVEL
• Sound pressure level is less than 70 dB(A).
01_EN_3P377464-4B.fm Page 4 Monday, April 13, 2015 9:29 AM
To Next Page
Loading...
