What does error code UA mean on Daikin FXMQ-P Air Conditioner?
Daikin Air Conditioner error code UA can be caused by: * The indoor unit refrigerant type is not compatible with the outdoor unit: Change the system layout and remove the incompatible indoor unit from the system. * The outdoor unit is not compatible with the self-cleaning panel (up to VRVII): Mount a standard decoration panel.
What does error code UE mean on Daikin FXMQ-P?
Daikin Air Conditioner error code UE indicates a communication error with the central control device. Check the communication from the indoor unit to central control. Verify the existing group number set on the indoor unit and the registered group number in the central control.
What to do for Daikin Air Conditioner error code A0?
If your Daikin Air Conditioner displays error code A0, it may indicate a fault board. Check setting 22-1-3: T1-T2 NC. If correct, it indicates an indoor board fault.
What could cause a Daikin FXMQ-P Air Conditioner to display error code A1?
If your Daikin Air Conditioner is showing error code A1, the cause is a fault in the Eeprom. The suggested solution is to replace the board.
What should I do if my Daikin FXMQ-P Air Conditioner is showing error code A9?
If your Daikin Air Conditioner shows error code A9, it indicates an EV (expansion valve) motor fault. This could be due to: * **EV motor fault detection:** Check the signal board to the expansion valve. * **EV body leakage:** Check the temperature coil sensor at the closed EV cooling other indoor units.
General| Cooling Capacity | 2.5kW - 7.1kW |
|---|---|
| Power Supply | 220-240V, 50Hz |
| Energy Efficiency Ratio (EER) | Varies by model |
| Coefficient of Performance (COP) | Varies by model |
| Noise Level (Indoor) | 19 - 45 dB |
Records changes and updates made to the service manual over time.
Explains the overall VRV4 H/R system architecture and components.
Details the operational principles of the VRV heat recovery system.
Provides guidance on navigating the manual and finding specific information.
Guides users on accessing error codes and diagnostic data from remote controllers.
Lists common error codes with their causes and recommended solutions for troubleshooting.
Configuration settings for Daikin's wireless remote controllers.
Configuration settings for BRC2/3E52 wired remote controllers.
Configuration settings for BRC1D51/52 wired remote controllers.
Configuration settings for BRC1E51 wired remote controllers.
Configuration settings for BRC1E52 wired remote controllers.
Common field settings applicable across various Daikin indoor units.
Specific field settings for presence sensor accessories.
Field settings related to the selfcleaning panel feature.
Field settings for Daikin air curtain units.
Field settings specific to VKM unit models.
Field settings for specific indoor unit series like FXSQ, FXNQ, FXDQ, FXMQ, FXTQ.
Instructions for performing factory resets and configuring default settings.
To Next Page
