Daikin FXSQ-A - Page 23

ESIE15-11A | Part 3. Field settings 2. Wired remote controller BRC2/3E52
23/09/16 Page 23
VRV4 indoor units
3. Select Field Settings and press the
Menu/Enter button.
4. Highlight the "Mode No.", and select the
desired "Mode No." by using the 
(Up/Down) buttons. For the most
commonly-used field settings, refer to
page 25.
5. In the case of configuring the indoor
units individually during group control
(When Mode No. such as 20, 21, 22,
23, 25 are selected), highlight the unit
No. and select the "Indoor unit Number"
to be set by using the  (Up/Down)
buttons. (In the case of configuring as a
group, this operation is not needed.)
NOTE
• In the case of individual configuration per indoor unit, the current settings are
displayed.
• SECOND CODE NO. " - " means that there is no function available
• In the case of configuring as a group, all SECOND CODE NO. which may be set are
displayed as " * ".
6. Highlight the SECOND CODE NO. of
the FIRST CODE NO. to be changed
and select the desired SECOND CODE
NO. by using the  (Up/Down)
buttons. Multiple identical mode
number settings are available.
Test Operation
Maintenance Contact
Field Settings
Min Setpoints Differential
External Input Interlock
Group Address
1/3Service Settings
SettingReturn
Press the Menu/Enter button.
<Service settings>
3.
Field Settings
Unit No.
0
Mode
20
SettingReturn
Field Settings
Mode
10
SettingReturn
SECOND CODE NO.
<Field settings>
FIRST CODE (SW) NO.
In the case of group settingIn the case of individual
setting per indoor unit
4.
5.
6.
4.
6.
Press the Menu/Enter button.