EasyManua.ls Logo

Daikin FXSQ32MVE9 - 1-2 Electrical Specifications (50 Hz) (Models FXSQ20-63 MVE); 1-2 Electrical Specifications (50 Hz) (Models FXSQ80-125 MVE)

Daikin FXSQ32MVE9
22 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Indoor Units • Concealed Ceiling Unit • FXSQ-MVE9
1
1
•VRV
®
Systems • Indoor Units
4
1 Specifications
Standard Accessories Operation manual
Installation manual
Paper pattern for installation
Drain hose
Clamp metal
Insulation for fitting
Sealing pads
Clamps
Screws
Washer
Notes Nominal cooling capacities are based on : indoor temperature : 27°CDB, 19°CWB, outdoor temperature
: 35°CDB, equivalent refrigerant piping : 7.5m (horizontal)
Nominal heating capacities are based on : indoor temperature : 20°CDB, outdoor temperature : 7°CDB,
6°CWB, equivalent refrigerant piping : 7.5m (horizontal)
Capacities are net, including a deduction for cooling (an addition for heating) for indoor fan motor heat.
1-2 Electrical Specifications (50Hz) FXSQ20MVE9 FXSQ25MVE9 FXSQ32MVE9 FXSQ40MVE9 FXSQ50MVE9 FXSQ63MVE9
Power Supply Name VE
Phase 1~
Frequency Hz 50
Voltage V 220-240
Current Minimum circuit amps (MCA) A 0.5 0.5 0.5 0.6 0.9 1.1
Maximum fuse amps (MFA) A 15 15 15 15 15 15
Full load amps (FLA) A 0.4 0.4 0.4 0.5 0.7 0.9
Voltage range Minimum V -10%
Maximum V +10%
Notes Voltage range : units are suitable for use on electrical systems where voltage supplied to unit terminals
is not below or above listed range limits.
Maximum allowable voltage range variation between phases is 2%.
MCA/MFA : MCA = 1.25 x FLA
MFA is smaller than or equal to 4 x FLA
Next lower standard fuse rating minimum 15A
Select wire size based on the MCA
Instead of a fuse, use a circuit breaker
1-2 Electrical Specifications (50Hz) FXSQ80MVE9 FXSQ100MVE9 FXSQ125MVE9
Power Supply Name VE
Phase 1~
Frequency Hz 50
Voltage V 220-240
Current Minimum circuit amps (MCA) A 1.4 1.5 2.0
Maximum fuse amps (MFA) A 15 15 15
Full load amps (FLA) A 1.1 1.2 1.6
Voltage range Minimum V -10%
Maximum V +10%
Notes Voltage range : units are suitable for use on electrical systems where voltage supplied to unit terminals
is not below or above listed range limits.
Maximum allowable voltage range variation between phases is 2%.
MCA/MFA : MCA = 1.25 x FLA
MFA is smaller than or equal to 4 x FLA
Next lower standard fuse rating minimum 15A
Select wire size based on the MCA
Instead of a fuse, use a circuit breaker
1-1 Technical Specifications FXSQ80MVE9 FXSQ100MVE9 FXSQ125MVE9

Related product manuals