13 / English
Care and Cleaning
CAUTION
When cleaning the unit, be careful not to cut your hands with the
opposing pole plate or ionizer wires.
(It is safer to use rubber gloves.)
When cleaning the unit, be careful not to cut the ionizer wires.
Be sure to do in a shower-proof place such as bathroom or sink in a
kitchen.
Use only specified volume of liquid mild detergent.
Do not use powder detergent or alkaline detergent and scrub with
hard sponge. Distortion or damage to the equipment may result.
Cleaning the plasma ionizer
1) Ionized wire (8 pieces)
&OHDQRIIWKHLRQL]HUZLUHVDQGSHULSKHUDOUHVLQSDUWZLWKDVRIW
cloth.
2) Streamer discharger
&OHDQRIIWKHLQWHUQDOUHVLQSDUWZLWKDVRIWFORWK
(For removal, see page 11.)
3) Ionizing frame
&OHDQRIIWKHUHVLQSDUWZLWKDVRIWFORWK
8VHDFRWWRQEXGWRZLSHRIIGLUWRIRGGVKDSHGDUHDZKHUH
your finger does not reach.
%HFDUHIXOQRWWROHDYHELWVRIWLVVXH0DOIXQFWLRQPD\UHVXOW
NOTE
If the ionizer wires are cut;
Replacement is necessary. Contact your dealer.
2) Streamer discharger1) Ionized wire
3) Ionizing frame
* Gently wipe off the ionizer wires.
Pulling hard may cut them.
: Resin part *1
*1 Wipe off only the resin part.
*2 Do not touch the discharge needle.
Bending the needle will reduce
deodorizing performance.
Discharge
needle
*2
Cotton bud
* Use a cotton bud to wipe off dirt
of odd-shaped area.
To Next Page
Loading...
Need help?
General
